This episode's special guest host is Mike from Naps Knotty Works LLC! We go around the table talking shop but quickly dive down into a rabbit hole talking about lasers. When we finally start to see the light, we jump into a question about sanding that steers into a discussion on finishing and flocking.

Special Guest:
Mike from Naps Knotty Works LLC
https://www.instagram.com/naps_knotty_works_llc/

Episode Sponsored By:
National Abrasives (@Mirka_abrasives)
https://www.instagram.com/mirka_abrasives/
Promo Code 10% Off: MSDN10

Sponsors:
Totalboat
https://www.instagram.com/totalboat/
Promo Code 15% Off: sawdustnationpod

Jtechphotonics
https://www.instagram.com/jtechphotonics/


Questions Submitted By:
Roye_176
https://www.instagram.com/roye_176/


Mentions:
Veteran Wood Co
https://www.instagram.com/veteranwoodco/

If you would like to help the Community Over Competition cause buy a t-shirt from the link below!
https://veteranwoodco.com/collections/apparel/products/maker-community-project

Companies:

Odies Oil
 https://www.odiesoil.com/

Gloforge
https://www.glowforge.com

Raspberry Pi
https://www.raspberrypi.org/

Support the show