How to identify CamGuard in an oil analysis, erratic idles, how to check the oil, and what the wrong prop does to an engine are on tap for the latest episode. Email [email protected] for a chance to be on the show.

Join the world's largest aviation community at aopa.org/join

Full notes below:

Tan has a 1968 Piper Arrow 180. He has an erratic idle as the engine warms. Mike and Paul said it sounds like maybe sticky valves. He and his mechanic haven’t done the wobble test. It almost can’t be a spark plug, Mike said. Colleen said it could be an ignition harness. Paul suggest he could do an in-flight mag check to help verify. Even though it should start with morning sickness, Paul said it’s not unlikely that it’s a sticky valve. Fuel could also be an issue, as they’ve cleaned the injectors, which Mike, Paul, and Colleen think they induces more problems than it solves.

Dicky is concerned about his last oil analysis report. Some of his wear metals are much higher since he’s been using CamGuard, and he’s wondering whether that’s normal. High calcium and high phosphorus are CamGuard’s signatures on an oil analysis, according to Mike. One thing Mike noticed that Dicky didn’t ask about was high silica, indicating dirt in the engine. High silica usually brings high wear metals because the dirt acts to scrub the cylinders. Dicky said he had a problem with his air filter box, and had replaced a part.

Enock is trying to settle a flight school debate. He checked the oil and the instructor asked if he screwed the dipstick back in when checking it, or if he just tapped the stick to the top of the tube. Everyone he asked at the school had a different answer. Paul said he screws it back in to check. Colleen agrees. Mike said all the readings should be taken with a grain of salt. He recommends running about two-thirds full. Many type certificate data sheets have a minimum level. And the only somewhat accurate reading is the first one of the day when the oil has time to fully drain back into the sump.

Rex is doing his best to follow the hosts’ leaning guidance. He has an RV-8 with an IO-360 engine with high compression pistons and e-mags and a fixed pitch propeller. He isn’t able to lean full throttle, but he can at cruise power. Mike clarifies that the guidance to leave the throttle full forward was for constant-speed propellers. Operating lean of peak slows the combustion event. The flame front takes longer to propagate. Engines don’t like lean of peak if the rpm is too high because the faster speed of the engine doesn’t like the disparity. Mike said he lowers rpm while keeping the throttle full before he leans. Then Rex makes an off-handed comment about his prop pitch, which the hosts quickly pick up on. They are convinced he has the wrong prop. He’s only getting 2400 rpm at full power in cruise. He also had a denotation event, and is trying to determine what the normal timing is supposed to be.