July 01, 2025

"An airplane with no engine is worth nothing"

1 hour 1 minute

Oil is everywhere this time, with consumption and temperatures problems for three of our owners. Email [email protected] for a chance to get on the show.

Join the world's largest aviation community at aopa.org/join

Full notes below:

Mark has a Twin Comanche and is loving his new electronic ignition. He has an issue where oil temperature and CHTs are slightly different on one engine than the other. His oil temperature also spiked on one climbout on a hot day, and he’s wondering what’s wrong. He’s using the variable timing. Nothing like this happened prior to the ignition install. Paul suggested that maybe some baffling changed during the install. The

hosts narrow in on either airflow or oil flow as the culprit. Colleen said to

think of baffling not as trying to direct airflow across the engine, but a

system that creates a high pressure, pushing air through the cylinder cooling fins.

Chris is wondering what’s wrong with his new engine. He has a Cessna 206 and he put in a new Continental IO-550. After some initial runs, but found that it was burning about a quart of oil per four hours. On one flight is running a bit rough. It had turned out to be a failed magneto. They added an air/oil separator, which obviously didn’t help. He did some low level, high power runs that didn’t seem to help. At 100 hours he did a ring flush on Savvy’s recommendation. The ring flush seemed beneficial.

Then after 10 hours he had only burned a quart. They are now at 150 hours and they are at a quart every 4 or 5 hours, and they’ve done another ring flush and it’s burning less oil again. He’s wondering why the rings are clogging up. Mike immediately zeros in on the problem by asking how long Chris has been running straight weight oil. He admits it was 150 hours on the advice of his mechanic. AD oil helps to prevent sludge build-up.

Willie is wondering if you need an A&P to do an AMOC, or alternative method of compliance with an AD. The hosts describe the process, which can be completed by any “operator” meaning owner. So, one need not hold an A&P to request an AMOC. Most AMOCs apply only to the operator, although Mike said a manufacturer can develop a global AMOC that would apply to everyone.

Steve was flying his Cessna 182RG with a Lycoming O-540 that he recently top overhauled with all new cylinders. He flew low and at high power to break them in, and oil consumption stabilized. He flew another 15 hours on regular oil and Camgard with virtually no oil burn. Then on a flight he was asked to slow rapidly on approach, and on that one flight he lost oil at a rate of three-quarters of a quart per hour. The consumption eventually settled at around a quart every 2.3 hours. He’s wondering if ring flutter is real and whether it caused the increased oil consumption. He didn’t notice excessive oil on the airplane. A ring wash didn’t fix it. He eventually decided to just overhaul the cylinders again. On inspection they didn’t find anything. Mike would have suspected a broken ring

or expander spring. Paul wonders if the piston rings were wrong for the nickel cylinders Steve had installed. Unfortunately, he found a broken stud at 20 hours on his new cylinders. They hadn’t properly torqued 4 of the bolts on his cylinders, reinforcing Mike’s point that sometimes it’s better to leave cylinders in order to avoid maintenance induced failures.

...more

View all episodes

By AOPA

4.9

229229 ratings